Yamamiya Sengen-jinja Shrine and Nirayama Reverbatory Furnaces
Plan this ride
Recorded distance
233 km
Riding-time estimate
4 h 04
Journey
Recorded itinerary
Distance and timing basis
Ordered leg totals agree within rounding. Stop distances are approximate sums of rounded legs. Stops, delays, approach and any separate return travel add time. Basis: producer-declared routed record.
Reading history stays on this device. My road watch requires a separate selection; opening it does not subscribe this ride.
Distance and riding time are measured on the routed road. Check local closures and conditions before you ride.
From Fujinomiya it runs 233 km to Fujinomiya; allow about 4 h 04 of riding. It goes by way of Suyama Sengen-jinja Shrine, Lake Yamanakako, Nirayama Reverbatory Furnaces and back through Lake Yamanakako. The stored terrain estimate reaches about 900 m; a measured road-elevation profile is not available. It was put together for the scenery rather than the shortest line.
Scenic road chapters
Hakone Turnpike and Skyline
Slow enough to look. The surface follows the shoreline, so the corners arrive where the water decided, not where an engineer did. Water arrives beside the road and stays for 59 km. The line follows the shore because there is nowhere else for it to go.
Chapter facts
Length
62 km
Named road
Hakone Turnpike and Skyline
Waypoint introductions and full write-ups
1. Yamamiya Sengen-jinja Shrine
Fuji does not need an introduction, but the shrines around its foot deserve one. Yamamiya Sengen-jinja stands on the southwest side of the mountain at the edge of Fujinomiya, in Shizuoka Prefecture, and it is one of the old shrines dedicated to Konohanasakuya-hime, the blossoming princess who is the deity of Mount Fuji, and her cult spread to the whole country as the Sengen shrines. The Yamamiya precinct is a calm, cedar-shaded compound where the mountain presides from behind, and the main buildings stand in the old Edo-period style, with dark wood and copper roofing, and the mood of a place that has served pilgrims for centuries.
May refer to an earlier itinerary; verify against your selected route before riding.
Planning note
Yamamiya Sengen-jinja Shrine is where the day begins. Next is Suyama Sengen-jinja Shrine.
2. Suyama Sengen-jinja Shrine
On the southern flank of Mount Fuji, above the town of Susono, a quiet shrine stands among tall cedar trees at the start of one of the oldest climbing routes on the mountain. The Suyama Sengen-jinja is dedicated to the goddess of Fuji and marks the beginning of the Suyama trail, used by pilgrims for centuries before falling into disuse in the twentieth century and being partly revived in recent years. It is one of the component sites of Fujisan, Sacred Place and Source of Artistic Inspiration, listed by UNESCO in 2013.
May refer to an earlier itinerary; verify against your selected route before riding.
Planning note
Suyama Sengen-jinja Shrine comes up about 23 km into the recorded legs. Next is Lake Yamanakako.
3. Lake Yamanakako
Yamanakako is the largest and highest of the Fuji Five Lakes, lying at nearly a thousand metres at the eastern foot of Mount Fuji, and on a clear winter morning, with the snow cone of the mountain mirrored in still water, it delivers the view that sells a million postcards. The lake was formed when lava flows from Fuji dammed the valley, and it is shallow, with reed beds, swans and boating piers along the shore. In summer it is a cool escape from the heat of Tokyo, busy with families, rowing boats and lakeside cafés; in winter the crowds thin and the mountain is at its most impressive.
May refer to an earlier itinerary; verify against your selected route before riding.
Planning note
about 54 km into the recorded legs you reach Lake Yamanakako. Next is Nirayama Reverbatory Furnaces.
4. Nirayama Reverbatory Furnaces
Two pairs of tall brick chimneys stand in a quiet suburb at the base of the Izu Peninsula, looking strangely European against the green hills. They belong to the Nirayama reverberatory furnace, built in the 1850s to melt iron for casting cannons, at a time when Japan felt threatened by Western warships arriving in its waters. The project was led by Egawa Hidetatsu, the local magistrate, a forward-thinking official who studied Western military technology from Dutch books. He died before it was completed, and his son finished the work. It is the only surviving reverberatory furnace of its era in Japan that was actually used for casting, and since 2015 it has been part of the UNESCO site of the Sites of Japan's Meiji Industrial Revolution.